 |
 |
 |
 |
 |
|
Cut a 45 degree section from the tip of a 40 cm narrow tube an...
|
Push the neck of a large balloon as far as it will go over the...
|
Depress the balloon on top of the funnel and blow through the ...
|
Saw, length of hosepipe, vice, funnel with spout to fit housep...
|
The flared bell improves the sound of the horn made from a fun...
|
 |
 |
 |
 |
 |
|
Ruler, rigid plastic pipe, round file, drill, drill bits, cork...
|
Mark seven short lines along the side of the pipe, using the m...
|
Using the 3mm bit, drill a line of holes 3 mm from each mark, ...
|
Use the 5 mm bit and file to enlarge these holes to 7 mm in di...
|
Trim the cork until it fits tightly into the end of the pipe. ...
|
 |
 |
 |
 |
 |
|
Place your lips at the blow hole and blow steadily across it t...
|
Pen, vise, coping saw, ruler, steel rule, scissors, nylon guit...
|
Marking the first fret line using a steel rule and pen.
|
Calculate 17/18 of the distance between the bridge line and th...
|
Bevel the edges of the neck near the holes using a file.
|
 |
 |
 |
 |
 |
|
Using a 1.5 mm bit, drill four diagonal holes 1 cm apart throu...
|
Glue a 2mm square wood strip at each fret mark. Sand them down...
|
Add screws and screw eyes to the holes drilled in the neck.
|
Assembling all the pieces of the guitar.
|
Knot an end of each string. Pass the strings through the diago...
|
